How to Install Laminate Wood Flooring

Prior to the installation, laminate wood flooring should have rested for not less than 48 hours. This duration of time allows contraction and expansion that are brought about in the room by conditions such as humidity and temperature. Damaged floor should be removed in case of renovation, until the sub floor is revealed. The pry bar may be used to remove baseboard from the wall and set the pieces aside for re-installation.

Installing laminate wood flooring 

The wood laminate flooring should be cleared of any object, material or debris. After that you may troll out the underlay while avoiding overlapping. Fitting pieces should instead be cut where necessary as this helps the floor to be more resilient. It is very important to plan the layout. Here, you may consider the longest wall or the straightest. The length of planks is mostly determined by the length of walls and their widths. When using a power saw, the planks should be held upside down while when using a hand saw they should be held finished side up. Cramps may be necessary to hold the planks in position while cutting.

How to lay laminate wood flooring

Further on how to install laminate wood flooring, an expansion gap of about quarter inch should be left between the wall and the planks. Now the planks are ready for installation with the tongue facing the wall. They can now (planks) be connected with each other by connecting the tongues and the grooves. They may be fastened together using a pull bar or a hammer.

Read more post about flooring options : Stamped Concrete Patio Flooring Ideas .

For any laminate wood flooring to endure, additional rows may now be mounted progressively and taking into account that the planks need to be slid at an angle, the gently be pushed into position using the pry bar not forgetting to give a quarter inch expansion gap between the last plank and the wall. Around the door casing, do not cut the planks, instead cut the door casing using a jamb saw in small bits until it fits to preferred height.

After all the planks have been fitted, the baseboard may be reinstalled to cover expansion joints. Finishing nails and a hammer may be used to fix it to the wall.

Leave a Comment

Your email address will not be published.